DesignPoint Directions

DesignPoint has offices in Clark, New Jersey and Lancaster, Pennsylvania.

Clark, NJ Office
DesignPoint Solutions - Clark
136 Central Ave
Clark, NJ 07066

Directions:
DesignPoint Solutions is located ¼ mile off the Garden State Parkway (GSP), Exit 135, and is approximately 20 minutes from Newark Airport.

From the South - Take the GSP North to Exit 135 - Westfield/Clark. As you leave the GSP, stay left on the exit ramp following the sign toward Westfield. Enter the circle and follow the signs for Westfield (this will take you ¾'s of the way around the circle and you bear off to the right onto CENTRAL AVE). See Common Directions below.

From the North - Take the GSP South to Exit 135 - Westfield/Clark. Stay to the far right as you leave the GSP. This will dump you on to Central Ave heading toward Westfield. See Common Directions below.

From the East or West - Take I-287, I-78, US 22, or I-80 to the Garden State Parkway, and see directions above.

Common Directions - Take Central Ave past ShopRite, McDonald's and Burger King. We are the 2nd building on your right past Burger King - 136 Central Ave. It's a large, tan building - we are on the 1st floor. If you enter from the back of the building, we are the second door on your left.

Hotels near our Clark Office
 

Lancaster,PA Office - Map
DesignPoint Solutions - Lancaster
1851 Charter Lane
Lancaster, PA 17601

Directions:
From the PA Turnpike - Follow the PA Turnpike west to exit 286 (Old Exit 21,  Lancaster/Reading) Just after the exit, take Route 222 south to Lancaster (about 15 to 20 minutes) At Lancaster, take Route 30 east about 3 or 4 exits to the "Greenfield Road" exit Follow the exit ramp around to the right and go over the bridge. After the bridge, go straight thru 2 traffic lights. At the 3rd light (about ¼ mi), turn right on William Penn Way Take the first right (about 200 ft) onto Charter Lane Follow Charter up a small hill and around the left curve At the top, you will see a single story building on the right numbered 1851 Charter Lane. We are on the right hand side of the building.

Hotels near our Lancaster Office

Media, PA (SolidWorks) Office - Map
300 West State Street
Third Floor
Media, PA

Directions:
From the Philadelphia Airport - Take I-95 South ... Merge onto I-476 N via EXIT 7 toward PLYMOUTH MEETING ... Take EXIT 3 toward MEDIA ... Turn LEFT onto E BALTIMORE PIKE ... See Common Directions below

From the West via PA Turnpike - Exit the Turnpike at Valley Forge exit number 326 ... Take I-76 East for approx 5 miles ... Then take I-476 South for approx 12 miles ... Take the Media Exit #3 ... Turn RIGHT onto E BALTIMORE PIKE ... See Common Directions below

From the East via PA Turnpike - Exit the Turnpike at Valley Forge exit number 20 - Mid-County ... Then take I-476 South for approx 12 miles ... Take the Media Exit #3 ... Turn RIGHT onto E BALTIMORE PIKE ... See Common Directions

From Delaware Area - Take I-95 North ... Merge onto I-476 N via EXIT 7 toward PLYMOUTH MEETING ... Take EXIT 3 toward MEDIA ... Turn LEFT at the exit ramp onto E BALTIMORE PIKE ... See Common Directions

Common Directions - E BALTIMORE PIKE becomes E BALTIMORE AVE ... Turn RIGHT onto S ORANGE ST ... Make an immediate left onto Baker Street and the Parking Lot (Bring quarters for parking meters) ... The SolidWorks office is in the corner building at State Street and Orange Street ... 300 West State St, Third Floor