Last Updated on by
Prevent future design failures by knowing exactly when and how your products will fail using SOLIDWORKS Simulation. Watch this webinar for the details!
In part three of this webinar series, you will learn how to run studies on a broken plastic part from a set of headphones in SOLIDWORKS Simulation to prevent it from breaking again!
In just 15 minutes, you’ll learn how to:
- Set up your study
- Run your study and analyze the results
- Make changes and re-run your study
- Compare results side by side
More in this Category
↓
September 4, 2012
February 17, 2020
February 7, 2020